Posted on | March 15, 2012 | Comments Off
Experts Recommend: How To Give Your Car The Summer Cooling – Air Conditioning, Sun Visor, Uv –
Firstly, Car Air conditioning cooling the outer loop is considered one of the most efficient way to open outside the circle, wind at maximum position, and open all windows and Skylight . As the hot air is less dense, when the outside cold air to enter when the cab of the hot air from the windows and Skylight Scattered outside, to the rapid cooling purposes. So after a few minutes, the car will quickly reduce the temperature. You can then travel some distance. As the driving, the vehicle speed and air flow, pressure smaller vehicle will accelerate the distribution of hot air out, to achieve rapid cooling purposes. After closing the windows and skylights, adjust the reasonable amount of wind, or open the internal circulation, enter the normal state of the air-conditioning use. This cooling effect is not only good, but the engine can also play a protective effect.
Second, you can use the sun visor and foil. Vehicle when parked, placed in the front windshield sun visor office, not only heat, but also protect the dashboard from sun. Visor reflectivity greater the effect the better. In addition, the windows of the foil also prevents the car’s air is solar heating, a good foil to prevent over 70% of the light (including ultraviolet) into. Good car film can effectively block the sun’s heat, reducing air conditioning load, to prevent the items inside the car fading aging, and also offers explosion-proof features. Selection of vehicles membrane, the membrane targeting light bulbs can heat source, the first measurement of the insulation film cars, clean foil when in a closed indoor environment. Installation of vehicle sunshade can achieve the same purpose.
Also can take some preventive measures, such as car parked in a cool ventilated place, or to the rear towards the direction of sunlight, because the rear window smaller than the front windshield, thus reducing the heat in the car.
Need special attention, there are some methods for the automotive temperature seems reasonable, but in reality is very damaging to the car, do not use. After boiling in water, such as the radiator, there is some internal pressure, then immediately open the radiator if additional outlets, hot water will be emitted out. Correct approach is to boil the water tank was found immediately after the full opening shutters in order to increase air flow until the water temperature drop is no longer the boil, cover with water to unscrew the radiator is blocked by water vapor released, wait a moment and then all open.
Some drivers find that the water inside the radiator boiling, immediately turn off. In fact, this approach does not, at this time can set, cylinder wall, cylinder head temperature is too high, if the flame at this time, parts are in the expansive, all with a very small space, parking will result in some loss of soft metal, there even lead to sticky cylinder. Should remain idle at this time, all open the shutters.
Engines and Tire Temperature is too high, not pour cold water on cooling. The correct way is to check before driving it to add a little cooling water, check the thermostat is working, driving and pay attention to water temperature in the table reading the instructions, can not exceed 95 . Temperature is too high, in order to enhance the convective cooling air can set off the hood to facilitate ventilation and heat dissipation.
Tire temperature is too high is often inaccurate because of installation, speeding and other causes, or the result of natural climate hot. If the tire temperature is high when sprayed with cold water will inevitably cause the child as the internal structure of the cold and sudden changes, resulting in the internal carcass deformation between the different layers of ply, so the early tire damage, and even lead to spin-off of cord. Such as wading, should be appropriate to reduce the tire temperature and then waded to prevent early tire damage.